PEDL90008 programmable 4-way footswitch with tuner function

Exclusively for MG series amps
The PEDL90008 footswitch is compatible with the programmable FX models of the Marshall MG series (from 15 watts). Please note that it cannot be used with any other amplifier and will not be accidentally connected there. If in doubt, ask your Marshall dealer for the right footswitch for your device.

Patented foot switch technology
For stylistically versatile guitarists, it's not just important to have tonally flexible amplifiers - it's just as important to be able to select the sounds of these amplifiers in a practical way. The non-plus-ultra of footswitch technology comes from Marshall. Marshall was granted a worldwide patent for the programming option of foot switches. The PEDL90008 is subject to this patent - and offers the user the opportunity to determine which of its four foot switches performs which function as desired.

Remote control according to your taste...
What should it be - Do you want to copy the switching functions of the amp or would you rather call up complete presets? Or both? Each individual button on the PEDL90008 can take on a switching function of the MG amp as required, or can also call up its own preset including all switching functions and control settings (except master volume). Of course, these functions can also be mixed as desired, for example 3 presets and FX on/off switching on the fourth switch - it couldn't be more convenient. In the factory settings of the amplifiers, the switching functions are assigned as follows:

Switch 1. Clean / Crunch
Switch 2: OD1 / OD2
Switch 3: FX on/off
Switch 4: Tuner & mute on/off

The footswitch functions remain stored in the amplifier, so that a replacement footswitch can be used if necessary without having to re-program.

Always keep an eye on operating states...
Of course, it won't be a problem for you to hear which sound you have just selected. But it's just a good feeling to be able to use the function displays on your footswitch to see at any time which channel you have currently selected, whether the effects loop is activated and whether the reverb or other internal effects are in operation. In addition, the current delay time is visualized by flashing the TAP LED. In tuner mode , these displays serve the tuner function.

Simply connect - no battery, no special cable!
Despite its extensive functionality, the PEDL90008 is connected to your MG amplifier with a simple jack cable (and this doesn't even have to be shielded...). The data transmission to the amplifier is digital, even if the amp itself of course delivers official, analogue sounds! And the power supply for the electronics of the foot switch, the tuner and the displays does not require a battery, but is supplied directly by the amp . This ensures operational safety and stress-free setup before the gig.

Automatic, chromatic tuner included...
A tuner is not needed on the amplifier, but on stage, directly on the control center of your amp. Therefore, a practical automatic tuner has been integrated into the PEDL90008 pedal. Automatic means that you receive a display of the tone being played directly and without switching between the individual tones. The integrated tuner (with a fixed 440Hz reference for the concert pitch "a") works chromatically and shows the note played on the display, if necessary. also with "Sharp" LED for increasing by a semitone. The 5 LEDs of the function display enable fine tuning. As can be seen above, the tuner function can also be accessed using a foot switch, while the amplifier is muted at the same time.

Mechanical decoupling of the foot switches
Marshall paid particular attention to the indestructibility of the Stompware footswitch. The micro buttons integrated in the switch electronics are controlled by conical compression springs arranged above them, so that these springs compress rather than the buttons being mechanically overloaded (e.g. by jumping on the foot switch...). You couldn't build a more reliable footswitch!